Having done my best with the wire brushes, I used Hammerite Rust Remover to sort the remaining rust. I'm not particularly impressed with this slimy green mixture but it seems to work alright and is inexpensive. When its gone I will replace it with the equivalent product from Bilt Hamber Laboratories, which I have heard great things about!
I still have the area around the clutch cylinder to wire brush but I sprayed the rest with primer just to minimise exposure to the air while I finish the rest off. This is how it's looking so far...
Another thing I've been getting on with is the drivers side quater valance. This now just needs flatting down and respraying before abrasive polish and then laquer can be applied. It's looking good so far but I'm not sure how close a match the colour is to the rest of the car!
Continuing the theme of modding the front of the car, I also cut the number plate horizontally so that it is the minimum size allowable by law. This means that there is only 11mm between the top of the letters and the edge of the plate. This gives a slight airflow advantage into the radiator because the area of the plate is reduced by 40 square cm. I think it looks better as well and saves 15g!
Finally, it also occured to me that I havent yet shown a picture of the T handle that I have fitted to the interior. This will eventually be used to activate a plumbed in fire extinguisher system but for the time being the cable remains curled up in the glovebox. I had initially planned to mount this in the dash but I made up a braket and mounted it just under the dash on the passenger side where the driver can reach it as well!



So I made them from 1mm steel and drilled them to fit the CD changer before bending them in a vice and spraying them with zinc primer, silver wheel paint and then lacquer. I will mount this on the panel inside the boot on the left hand side (to offset the drivers weight and as low as possible to keep the centre of gravity low!)
Also while I had the drill out I reduced the weight of the overengineered bracket that attaches to the chassis to the front and holds the plastic grill on. I may well drill out the horizontal parts of the grill in the future. Believe me I have a lot of time on my hands!







The nearly finished inlet ports looks a whole lot better than they did to start with!
And I'm also about halfway through polishing the chambers!